Stickler Promatac White WK120
Stickler Promatac White can be printed with a variety of print techniques from letterpress, flexo, offset and screen printing.
It is recommended to let printed graphics cure effectively for a full 72 hours before lamination and applying. This will help prevent edge-curling once it is applied. For graphics that are die-cut, it is recommended to leave 5mm of unprinted media all the way around the edge.
All statements, technical information and recommendation are based on tests we believe to be reliable, but the accuracy or completeness thereof is not guaranteed, and the following is made in lieu of all warranties of merchantability and fitness for the purpose: Sellers and manufacturer’s only obligation shall be to replace such quantity of the product proved to be defective. Before using, user shall determine the suitability of the product for its intended use, and user assumes all risk and liability whatsoever in connection therewith.
Face Material:
|
Properties |
Test Method |
Result |
|
Grammage |
ISO 536 |
110 g/m2 |
|
Caliper |
ISO 534 |
80 microns |
|
Gloss 75° % |
> 65 |
TAPPI T480 |
|
Breaking % |
> 200 |
ISO 1924 |
Adhesive: AP940 Permanent Acrylic
Permanent acrylic adhesive. High tack and excellent adhesion on a wide variety of materials, including apolar substrates (like PP and PE). Good adeing resistance to heat and sunlight with usage on slight rough textured surfaces. This adhesive complies with FDA 175.105
|
Properties |
Result |
|
Composition |
Water based acrylic |
|
Minimum application temperature |
+5°C |
|
Service temperature |
-30 to +120°C |
|
Shear FTM8 |
Very high |
|
Tack FTM9 |
8 N/Inch2 |
|
Final Tack FTM2 |
9 N/Inch |
Laminate:
|
Properties |
Result |
|
Laminate shelf life |
24 months stored at 20°C/50% RH |
|
Typical laminate caliper |
218 microns |
This technical specification includes our experience and know-how regards the following:
a) The composition of our products.
b) Their generic adhesive qualities normalised by means of the ISO procedure and regarding the international rule Finat generally accepted in this sector.
Any reference to final use is subjected to our good knowledge and opinion and does not imply specific irrevocable guarantees for final use in end product labelling and packaging.
Over and above these standards the product user is responsible for assessing, testing and ensuring the specific scope of the label in certain applications by means of prior generic official approval.
WK 120 one side siliconised white kraft liner design for exceptional lay flat capabilities, die-cutting and on press performance.
|
Properties |
Test Method |
Result |
|
Grammage |
ISO 536 |
120 ± 10% gsm |
|
Caliper |
ISO 534 |
118 ± 10% microns |