Digitac Outdoor Floor SAV

Digitac Outdoor Floor SAV is a white gloss, deep grain embossed, anti slip vinyl with an aluminium construction and a permanent solvent acrylic adhesive. Perfect for outdoor applications on rough wall & floor surfaces such as concrete, asphalt, brick, tiles, marble, terrazzo. Up to 1 year outdoor life.

    • Street graphics
    • Floor graphics
    • Wall graphics
    • Textured surfaces

    Test Items

    Result

    Test Method

    Peel (N/25mm) for 20 minutes

    1.4

    ASTM-1000 on glass

    Peel (N/25mm) for 24 hours

    1.5

    ASTM-1000 on glass

    Peel (N/25mm) at 70°C for 24 hours

    2.2

    ASTM-1000 on glass

    Initial Tack (ball no. 7/cm)

    0.1

    JIS on stainless steel

    Peel Adhesion to linear (g/25mm)

    19-20

    PSTC-1, 30cm/min

    Dimension (min), holding power

    1500↑

    PSTC-7

     Installation:

     

     

     

     

    Removal:

    Sweep the application surface to remove contaminants (dust, dirt, water etc.) & ensure it is completely dry.

    If the surface is oily, please power wash with commercial degreaser. 

    Peel off the release liner, lay the vinyl flat on the surface and apply pressure over the complete surface area of the vinyl with a J-roller or hard rubber roller, rolling moving from the centre to the edge.

    Make sure all edges of the film have completely adhered to the surface.

     

     

    Use a putty knife (or blade) to peel up a corner, then pull the vinyl away from the surface at an angle less than 45 degrees. 

    No residue remains on the surface with peel-off removal. 

    If the graphics are installed on asphalt or other rough surfaces in locations with heavy vehicle traffic, the vinyl could be difficult to remove and may require power washing at a low angle to remove worn-in graphics

     

    Longevity:

     

    Printing:

     

    Adhesive:

     

    Release Liner:

     

    Application Temperature:

    Suitable up to 1 year outdoor

      

    Eco-solvent, UV and Latex

     

    Permanent Solvent Acrylic

     

     Double PE coated

     

     +10℃ ~ + 60℃ ~

     

    Outdoor life: 

    General life times refer to the durability of the unprinted face film when subject to vertical exposure in temperate, non-extreme conditions. Actual performance life will depend on media and surface preparation and exposure conditions. For example the direction and angle of the sign; in areas of long, high temperature exposure; in areas of high pollution or high altitudes, outdoor performance will be decreased.

    All values presented in this data sheet provide the general characteristics of the product. It is the responsibility of the customer and/or end user to determine that the product is fit for the specific application it is to be used for.  All values presented in this data sheet provide the general characteristics of the product. It is the responsibility of the customer and/or end user to determine that the product is fit for the specific application it is to be used for.