Clear Focus CurvaLam
- Optically clear 2-mil cast vinyl over laminating film
- Made for use on surfaces that are flat or have simple curves
- Protective over laminate specifically designed for use with Clear Focus® One Way Vision films
- Non printable
- Protects graphics against marking and scuffing,
- Enhances the water resistance of graphics and provides UV protection, thereby increasing the life of the printed image.
- For application onto flat or simple curved surfaces.
- For use with vehicle graphics and other outdoor applications.
Available in Gloss Clear 1370 x 30 and 1520 x 30.5
Makeup Cast polymeric gloss flexible vinyl cold-laminating film with an optically clear permanent pressure-sensitive acrylic adhesive and sinqle laver clear polvester release liner.
Film Thickness 76 microns, approx., for vinyl and adhesive.
Release Liner: 38 microns, approx
Adhesive Permanent acrylic adhesive. Adhesion 0.625 kq/cm. Tensile 0.8 kq/cm.
Standard Widths/Lengths 1370mm x 7.62m 30.48m on 76mm core
Dimensional Stability Excellent. 137 microns after 48 hours at 70'c
Application Temperatures Recommended: 15"c to 25"c, Min: 5'c On clean dry substrate Max: 38"c (in shade)
Service Temperatures -'l 7ec to +60'c
Expected Lifetime Up to 2 years for external applications, up to 5 years for internal applications. Colour fading
is dependent upon the quality and type of inks used, degree of sun exposure and ink load when printing. Testing recommended before production to determine suitability of product for intended application.
UV Resistance Good to excellent
Chemical Resistance Good. Detergents - No Effect 1"1 24 hours. Petrol and Oil - No effect 1"t 10 mins. 100%
Ammonium Hvdroxide - No effect 1"t 1O mins
Storage Stabilitv 2 vears shelf life when stored at21"c & 50% relative humidity
Gloss & Optical Level 60-90% (crystal) when measured at 60' reflection. Maximum optically clear property is at 90', reducing as the angle decreases off the perpendicular. May take 2-4 weeks after
installation for ooticallv clear propertv to become apparent.
Printing Not required, although film is printable using solvent inks. Print image on non-adhesive
side, in reverse image format. Allow for extra drying time.
lnstallation Referto the Surface Preparation and lnstallation lnstruction Faet Sheets; Applyto clean;;
dry glass surface. Use mild soap (wax free) and water, dry glass well. Do NOT use
amrionia, Windex@ or other solvent-based glass cleaner prior to application. Do nottUse
heat. For use roll fed cold laminator.
Removal Refer to the Care and Removal Fact Sheet. Remove by peeling from surface.
Warranty and Disclaimer :
Refer to the Warranty Statement Fact Sheet. The information in this dala sheet is presented
for reference and illustration of general product characteristics only. The,informati0n does,
not constitute a representation or warranty relating to the suitability or fitness for a particular
application or otherwise create guarantees of product performance. ln all cases, purchasers
should independently determine, prior to use, the suitability of this product for their specifie