ALC Floor Graphic
- Monomeric, deep grain textured matt floor graphic over-laminate with a PE liner
- Perfect for floor graphic or vertical application
- Tested to AS/NZS 4586:2004 standard slip resistance classification of new pedestrian surfaces appendix A & B
- 200um film for longer non-slip usage & greater scratch resistance
- UV treated
- Up to 12 months indoor floor graphic application
Construction - Monomeric PVC, Acid Free Usage - PSA Cold Laminating
PVC Thickness - 200 microns Liner Thickness - 120 gsm single sided PE coated paper
Adhesive Thickness - 25 microns Solvent based acrylic (permanent) pressure sensitive
Total Thickness - 225 microns Stick Factor - #7 (Ball)
Outdoor Vertical Applicaiton - up to 2 years depending on position and application*
Indoor Floor Application - up to 12 months depending on position and application*
Core - 76mm
Suitable for: Internal Floor Graphic Lamination or Vertical Application.
Testing:
CSIRO Report No.: 7547 - Slip Resistant Testing, Floor Lamination Film AS 4586:2013
Report Available on request
Laminating Recommendations: To ensure the integrity of the product is maintained and the adhesion (stick) factor is
not altered, it is vital to apply the laminate to the print through a roll laminator (do not wet apply). For optimal results it is
recommended to use a heat assist laminator to a temperature of 50°C and to avoid curl the tension should be as little as
possible (nill is best). The maximum nip pressure (whilst avoiding creasing) should be selected on your laminator. Prints
should be degassed for 24 hours if hung vertically and for 48 hours if left horizontal to ensure sufficent degassing of inks
prior to lamination. Laminating protects against abrasion, moisture and constant print surface contact.
Laminating Temperature: Cold or heat assist up to 50°C
Shelf Life: 1 year (stored up to 25°C and 50% relative humidity), in original packing of the box.
Test Items |
Test Result |
Standard |
Test Method |
Thickness, mm (without parer and adhesive) |
0.2032 |
0.20 ± 0.01 |
ASTM-D-1593 |
Dynes/cm |
36 |
32 |
ASTM-D-882A |
Tensile strength (kg/cm ²) MD: CD: |
293 267 |
190 190 |
ASTM-D-882A |
Elmendorf (g/mil) MD: CD: |
85.1 119.1 |
20 20 |
ASTM-D-882A |
Elongation (%) MD: CD: |
212 211 |
100 100 |
ASTM-882A |
Dimensional Stability (%) MD: |
3.6 |
5.5 |
ASTM-D-1204 |
All statements, technical information and recommendation are based on tests we believe to be reliable, but the accuracy or completeness thereof is not guaranteed, and the following is made in lieu of all warranties of merchantability and fitness for the purpose: Sellers and manufacturer’s only obligation shall be to replace such quantity of the product proved to be defective. Before using, user shall determine the suitability of the product for its intended use, and user assumes all risk and liability whatsoever in connection therewith.